Zitat Zitat von Gnom67 Beitrag anzeigen
Nett, dass du uns gleich den Link dazu schickst...
Ich hatte nicht den Eindruck, dass es hier so wirklich weiter hilft. Außerdem wurde ein anderer Link zum selben Manual ja schon gepostet.

Was mich aber mehr irritiert, ist dass bei deinem Link zum SR-Bus die Geräte auf den Fotos immer einen Ein- und Ausgang haben. Das hat das Tapedeck offensichtlich nicht. Kann es vielleicht wirklich nur das was da unten in deinem Link steht

The tape deck can be set to start and stop recording when the CD player starts play and stop when CD play stops. The bus is again a simple +5V TTL rail that is held high by the receiver (The tape deck). When the CD player (the sender) is playing, it pulls the rail down to 0V (GND). Again as with the SR bus described above, the ground connection between the two units is made with audio ground. When play stops, the CD player releases the rail and it goes back to its normal +5V state.
Das würde zur Beschriftung /REMT als low actives Signal im Schaltplan passen.