Atmel Studio6 mit AVR Dragon ISP Failed to enter programming mode

[Wsk8]

Start a Debug session.

From the Debug menu: (Dragon options) Disable debugWire

Follow the instructions religiously.

Note that Studio 5 can only disable dW if you have a separate power supply to your AVR. i.e. do NOT use Dragon power.

Vlt hilft ja das.

mfg

[Manzano]

Wenn ich Debug mit F5 starte, kommt die Meldung
"ISP on AVR Dragon does not support Debugging. Device is only programmed. Use start without debugging to avoid this message."

Und per JTAG angeschlossen beim Versuch die ID auszulesen kommt:
"JTAGID not valid. Debugger command enterProgMode failed., ModuleName: TCF (TCF command: Device:startSession failed.)"