Hallo dussel07,
danke für Deine Antwort!
Vor dem Kauf dachte ich, die Software für einen Quadrocopter wäre bereits installiert.
War aber nicht! Habe das Modul mit einem Skop abgefragt...an den 6x Motorsteckern liegt kein
Signal an obwohl ich vom Empfänger die Pins AIL, ELE, THR und RUDD kontaktiert hatte.
Als Sender dient eine MC22 von Graupner.
Vom Verkäufer kam diese mail:
Hi Rolf,
Does the LED blink? about 1 time second ?
I loaded a test firmware for you, that is not for fly, if you power it
on, the LED should blinking, about1 time / second.

before you connect it to receiver, please load a flight firmware for
the board, you can download the firmwares from here:
http://www.kkmulticopter.com/index.p...layout=default

if you don't load a firmware, the board will don;t work.

if you loaded a firmware, the board still doesn't work, please tell me
which firmware you loaded, and the fuse setting for the board you
used.
if it is possible, please make a short video for the test progress,
then I can see it better.

If the board defect, I will send a new one to you, but please check it first

Regards
Yanan


Grüße

Rolf