eine Frage zum sd21 Servocontroller.
Bedeutet der unten stehende Text, vom Entwickler des sd21, dass die Logic Spannung aus der Servospannungsquelle, die von 6v -7.2v geht, gezogen wird? (wenn der jumper sitzt)
Und bedeutet das auch, wenn ich ein 7.2v servo akku habe und!! ein eigenen logic akku habe, (jumper steckt dann natürlich nicht mehr) dass er dann auch größere akkus als 5v, am logic "port", annimmt? und sich aus, z.b.8v logic akku, 5v rausnimmt?
Oder müssen dann in dem 2 akkku fall wir ein 5v akku für logic spannung nehmen?


Power
There are two ways to power the SD21. The first is to used a 5v supply for the processor section and a separate 6v-7.2v supply for the servo's. This is the recommend method, and the 4-way terminal block allows for this option. The logic and servo grounds are internally connected on the PCB. Not everyone wants to use two batteries, so we have allowed for the use of a single (typically 7.2v) battery to power the servo's and the module. To do this place a link on the two pin header below the terminal block. This routes servo power to a low drop 5v regulator which supplies the logic. The connections must be made to the servo terminals on the terminal block - NOT the logic ones. The SD21 monitors the servo battery voltage, which is available for reading from an internal register.