wow wo hast du die pdf den gefunden? klasse

6.1.2 ACG Test-Antenna
Tightly wind 70 turns of 0,22mm enamelled solid copper wire on 36mm
diameter.
Leave about 50 mm free at one end and about 30mm at the other, cross the
wires (at the +/- 30 mm point) and secure them together using the tape
Twist a 4mm diameter spriband onto the coil that you have just made, leaving
the start and finish ends free.
Solder an 11Ohm resistor (½W, R ±1%) in series to the shorter end of the free
antenna leads.
This should lead to an antenna with 395 H and a Q=20,5.

kann das mal jemand übersetzen werd da net draus schlau.. *gg