Hallo Zusammen,
ich mache mal keinen neuen Thread auf, da der Thread Titel ganz gut passt.
Wenn ich mit Servos = .... Servos ansteuern will... kommt beim kompilieren unknown interrupt source...
selbst wenn ich das Beispiel aus der Hilfe in ein leeres Programm kopiere und kompilieren will, kommt dieser Fehler.
Hat jemand Abhilfe?
Code:
'-----------------------------------------------------------------------
' (c) 2001-2005 MCS Electronics
' servo.bas demonstrates the SERVO option
'-----------------------------------------------------------------------
'Servo's need a pulse in order to operate
'with the config statement CONFIG Servos we can specify how many servo's we
'will use and which port pins are used
'A maximum of 16 Servos might be used
'The SERVO statements use one byte for an interrupt counter and the TIMER0
'This means that you can not use TIMER0 anymore
'The reload value specifies the interval of the timer in uS
'Config Servos = 2 , Servo1 = Portb.0 , Servo2 = Portb.1 , Reload = 10
$regfile = "2313def.dat"
Config Servos = 1 , Servo1 = Portb.0 , Reload = 10
'as an option you can use TIMER1
'Config Servos = 2 , Servo1 = Portb.0 , Servo2 = Portb.1 , Reload = 10 , Timer = Timer1
'we use 2 Servos with 10 uS resolution(steps)
'we must configure the port pins used to act as output
Config Portb = Output
'finally we must turn on the global interrupt
Enable Interrupts
'the servo() array is created automatic. You can used it to set the
'time the servo must be on
Servo(1) = 10 '10 times 10 = 100 uS on
'Servo(2) = 20 '20 times 10 = 200 uS on
Do
Loop
Dim I As Byte
Do
For I = 0 To 100
Servo(1) = I
Waitms 1000
Next
For I = 100 To 0 Step -1
' Servo(1) = I
Waitms 1000
Next
Loop
End
Zitieren
Zitat von Luca-33
Lesezeichen