@jon
C1 habe ich hierher. (da wird zwar nur nen 6pol ISP verwendet, aber das spielt ja keine rolle?!)

@franzl
bei ponyprog habe ich LPT1 Parallel I/O eingestellt und als device den mega8.
calibiert habe ich das auch.

uisp verwende ich immer wiefolgt (habe das irgendo gelesen, dass damit einer einen atmega8 programmiert hat):
Code:
/home/krampfda# uisp -dplt=/dev/parport0 -dprog=dapa
Es gibt bei dem programm allerdings noch weitere Optionen:
(Vielleicht kann damit jemand was anfangen)

Code:
Programming Methods:
  -dprog=avr910    Standard Atmel Serial Programmer/Atmel Low Cost Programmer
         pavr      http://www.avr1.org/pavr/pavr.html
         stk500    Atmel STK500
         avrisp    Atmel AVRISP (uses stk500 protocol, but can only perform
                   serial programming using SPI)
  -dprog=dapa|stk200|abb|atdh|avrisp|bsd|fbprg|dt006|maxi|xil|dasa|dasa2|dasa3
       Programmer type:
         dapa      Direct AVR Parallel Access
         stk200    Parallel Starter Kit STK200, STK300
         abb       Altera ByteBlasterMV Parallel Port Download Cable
         atdh      Atmel-ISP Download Cable
         paravrisp [Unknown origin] Parallel port Programmer
         bsd       http://www.bsdhome.com/avrdude/ (parallel)
         fbprg     http://ln.com.ua/~real/avreal/adapters.html (parallel)
         dt006     http://www.dontronics.com/dt006.html (parallel)
         maxi      Investment Technologies Maxi (parallel)
         xil       Xilinx HW-JTAG-PC Cable (parallel)
         ett       ETT AVR Programmer V2.0 [from Futurlec] (parallel)
         dm04      Datamekatronik 2004 (parallel)
         dasa      serial (RESET=RTS SCK=DTR MOSI=TXD MISO=CTS)
         dasa2     serial (RESET=!TXD SCK=RTS MOSI=DTR MISO=CTS)
         dasa3     serial (RESET=!DTR SCK=RTS MOSI=TXD MISO=CTS)

Target Device Selection:
  -dpart       Set  target abbreviated name or number. For some programmers, if
               -dpart is not given programmer's supported devices  are  listed.
               Set  -dpart=auto for auto-select. Auto-select does not work with
               all programmers, so it is recommended to always specify a target
               device explicitly.

Parallel Device Settings:
  -dlpt=       specify device name (Linux ppdev, FreeBSD ppi, serial)
               or direct I/O parallel port address (0x378, 0x278, 0x3BC)
  -dno-poll    Program without data polling (a little slower)
  -dno-retry   Disable retries of program enable command
  -dvoltage    Set timing specs according to the power supply voltage in [V]
               (default 3.0)
  -dt_sck      Set minimum SCK high/low time in micro-seconds (default 5)
  -dt_wd_flash Set FLASH maximum write delay time in micro-seconds
  -dt_wd_eeprom Set EEPROM maximum write delay time in micro-seconds
  -dt_reset    Set reset inactive (high) time in micro-seconds
  -dinvert=... Invert specified lines
               Use -v=3 option to see current settings.
  -d89         Allow parallel programming of AT89S51 and AT89S52 devices.
Gruß