Ich hab diesen Code:
Code:
$regfile = "m128def.dat"                                    'Define Chip ATmega128
$framesize = 32
$swstack = 32
$hwstack = 32
$crystal = 16000000
$baud = 9600
$baud1 = 9600

Config Com1 = Dummy , Synchrone = 0 , Parity = None , Stopbits = 1 , Databits = 8 , Clockpol = 0
Config Com2 = Dummy , Synchrone = 0 , Parity = None , Stopbits = 1 , Databits = 8 , Clockpol = 0

Schleife:
Open "Com2:" For Binary As #2
'Printbin #2 , Var
Close #2

Open "Com1:" For Binary As #1
'Printbin #1 , Var2
Close #1

Goto Schleife

End
(nicht getestet)

Und wie kann ich RS232 empfangen also wenn ich was in den Chip reinsende???

Mfg
Tobi