Hallo!!

Habe mal eine Frage, wenn ich den "Controlport" in Bascom zur Ansteuerung des gLCDs nutze, kann ich die "unbenutzten" Pins des "Controlports" trotzdem "normal" nutzen? Weil ich brauche davon ja nur 6, so wie ich es der Bascom-Hilfe entnehmen kann (s. Auszug).

The following connections were used for the T6963C:
PORTA.0 to PORTA.7 to DB0-DB7 of the LCD
PORTC.5 to FS, font select of LCD
PORTC.2 to CE, chip enable of LCD
PORTC.3 to CD, code/data select of LCD
PORTC.0 to WR of LCD, write
PORTC.1 to RD of LCD, read
PORTC.4 to RESET of LCD, reset LCD

Ich benutze einen mega16, würde dann Port C als Datenport und Port B als Controlport nutzen, klappt das so ohne weiteres, oder hat irgendwer irgendwelche Einwände?

Danke schonmal im Voraus!