SD20 über I2C an C-Control1 auf A.Board funktioniert nicht

[Windt H.J.]

Hello,
I’m sorry to hear that you C-Control is malfunctioning.
I have created a small test program for you to try.
You will need to use a terminal program because the program will ask you for a servo number and a servo position.
Make sure to use 2 power supply’s, 1 power supply for the C-Control and SD20(+5V from C-Control), the other power supply for your servo.
Remember to connect all the power supply GND’s (-) together.
Greetings,
H.J. Windt