öhöm *räusper*
Ich glaub ich hab mich versehen im Datenblatt,
da steht 1 <= freq (MHz) für deine Einstellungen.

Zitat Zitat von Manual
The CKOPT Fuse selects between two different Oscillator amplifier modes. When CKOPT is programmed, the Oscillator output will oscillate a full rail-to-rail swing on the output. This mode is suitable when operating in a very noisy environment or when the output from XTAL2 drives a second clock buffer. This mode has a wide frequency range. When CKOPT is unprogrammed, the Oscillator has a smaller output swing. This reduces power consumption considerably.
This mode has a limited frequency range and it cannot be used to drive other clock buffers.
Vielleicht macht das Probleme?
Werden die Quarze heiss? Oder der Controller? Sind die Quarze wirklich 'verbrannt' oder später wieder einsatzfähig?
Ich würd eher auf nen defekten µC tippen...