PDA

Archiv verlassen und diese Seite im Standarddesign anzeigen : Problem mit ADS1115 und ready Signal



Ritchie
24.02.2017, 22:08
Hallo Zusammen,

verwendet von Euch jemand den ADS1115 in Verbindung mit dem ALARM/RDY Signal ?

Ich verwende folgende Init Routine und sofort habe ich Impuls auf dem RDY Signal,
obwohl ich nur eine einize Messung haben will (Single Shoot).


ret = i2c_start(ADS1115_I2C_BUS_ADRESS+I2C_WRITE); // set device address and write mode
if ( ret )
{
i2c_stop(); /* failed to issue start condition, possibly no device found */
}
else
{
i2c_write(ADS1115_RA_LO_THRESH); // Select the Pointer register with Low thread hold
i2c_write(0x00); // write value zero into the high Byte
i2c_write(0x00); // write value zero into the low Byte
i2c_stop(); // set stop condition = release bus
}

ret = i2c_start(ADS1115_I2C_BUS_ADRESS+I2C_WRITE); // set device address and write mode
if ( ret )
{
i2c_stop(); /* failed to issue start condition, possibly no device found */
}
else
{
i2c_write(ADS1115_RA_HI_THRESH); // Select the Pointer register with High thread hold
i2c_write(0x80); // write value max. value into the high Byte
i2c_write(0x00); // write value max. value into the low Byte
i2c_stop(); // set stop condition = release bus
}

iActualAnalogInput=4; // read the last once for init function of the Ready pin
ret = i2c_start(ADS1115_I2C_BUS_ADRESS+I2C_WRITE); // set device address and write mode
if ( ret )
{
i2c_stop(); /* failed to issue start condition, possibly no device found */
}
else
{
i2c_write(ADS1115_RA_CONFIG); // Select the Pointer register with Configuration
iRegisterValue = 0xC1; // OS Mode / 6.111v Full range / Single shot
i2c_write(iRegisterValue); // write value into the High Byte of Config. Register
iRegisterValue = 0x8C; // 128 SPS / Trans. Comp mode/High pole/Latched /After one conv.
i2c_write(iRegisterValue); // write value into the low Byte of Config. Register
i2c_stop(); // set stop condition = release bus
}


Wo mache ich den Fehler ?:(

Viele Grüße
R.